Three Tigers

    

Once I had to wait a bit so I can safely edit the wells it was finally here.
I can now sharpen and hone as I want and only have to check that it is not too warm.



So I'm now out the rough adjustment of the various upper trays.











After the rough work is done to the extent it is now doubling up with plastic sheets in the first well.
First, the termination strip on the rear. Fit and glue STABILITH express. Thus, the plastic sheets just will I push the tray on a flat surface.



Then carefully remove the ends of the side walls double up and be careful not to glue the transom.



After the glue is hard and then all course-filed carefully looks decent from the stern talk. In addition, the transom remains removable.

  complimenti edwin , quegli scafi nelle varie versioni con scafo e sospensioni in metallo li rendono modelli veramente ben fatti e inpreziositi di pura potenza , saluti e buon alvoro da robby62  

Now that I have also worked a second well in the same way I do now first with the suspension on.

For this I had to edit the rocker arms with the belt sander first. Since I use the original distances and the zinc rods are a bit too long, it was necessary to grind this bit. They can now easily swing past each other.





Then I started to wrap feathers times. I'm not quite finished yet because I still need a few more of them in the next two weeks, but it is progressing.

After I completed a few other studies, we are now further enhanced with the three tigers.

The springs are installed at the first ever pan on the rocker arms and tomorrow I'm doing this then at this tub ready and build it also in the other two wells.

  bella vista dall'alto dello scafo con barre di torsione del Tiger ...... saluti robby62:cia: 

And on it goes with the suspension.

First I built this done in the first well.





Then it went to the other two tigers on. I had to adjust the rocker arms careful with the belt sander first work. This is a dangerous job where you need to swing back cool every few seconds because he can not get warm because of the glue. If this comes off, the swing arm would be broken and this happens very quickly.





Eventually, however, even this work was then done without damage to one and I was able to install the suspension in the second tiger.



Then tomorrow is the third in the series.

Complimenti mi sembra proprio un buon lavoro quello che stai facendo..... 

Now the suspension of the third well in the series.

The rocker arms and springs are already installed. It still lacks the counter-holder of the springs and I have the tub as the two first even double up with plastic sheets, but that's just a formality.



Here I have a swing times as I install it.
He is mounted on 19mm length of your silver steel shaft in a brass bearing in the tub and gets a dirt seal from outside an O-seal. The, the weight of the tank is inserted into a matching tongue of the actuating ring is clamped with two set screws to the M3 axis. Thus, the suspension is very stable and fully adjustable and is held securely by the double clamping.

you are very good... 

congratulations...