Three Tigers

Hello,

today has been running all day and by the way my router so I can start soon with the bonding of three new Tiger tanks. This will allesammt equipped with brushless motors and real inertia and two of them I will also build completely.

  evviva un nw progetto caro edwin , il mitico Tiger I ........  saluti e alle prossime news sul tuo modello .... saluti e buona serata robby62  e riky94:king:  .......   (( ps. scusa se scrivo in italiano ma con l'inglese come avrai notato ci mastico poco   ))

Hi Robby,

I know the problem with the translations only too well.
For me it is often not understood what it really is in a post, but I lkerne this and it's getting better.... 

regards Edwin

Edwin-Apamotec ha scritto:

Hi Robby,

I know the problem with the translations only too well.
For me it is often not understood what it really is in a post, but I lkerne this and it's getting better.... 

regards Edwin

  .............   robby62  

And also in the three tigers it goes on.
But currently I am working first so that a whole lot of free stuff for the drive of three tigers and a panther, as an aside to make the moves along.

First, I have a whole handful of collars with double clamping and a few made ​​with Simple.









And then today, the axle for four tubs.

  caro edwin , che pazienza ma soprattutto che gran passione metti anche in quei lavoretti di precisione e pazienza , buona domenica da robby62 e riky94  

Slowly, I can now start with the stick of the three tigers.

The first step is as always to stick with the other arm bearing retainer.

For this, I must first deburring the aluminum strips, rub the holes, sand and degrease.



Then I can put the stock into the appropriate holes with some glue and place it on a flat surface and complain.



But in order to glue the tubs I still need the supports of the chain tensioner. For this I turn off an aluminum rod to 25mm diameter.



After I cut 8 pieces for 4 trays, they were turned on on both sides of a 2mm paragraph.





After I made in the middle of a 6mm hole for the Exenterachse missing the lock. I'm doing this as I drill a 3.2 mm hole in the side of the M4 I cut a Gweinde. Thus, all the mounting brackets are then completed after repeated rubbing of the center hole.

  fantastiche novita dal tuo magico tornio con quei ruotini metallici ...    saluti e buona serat robby62...  

And already I can stick with the start of the first well.

First, of course, the parts deburring, sand, degreasing and dry adjust.



The Simple tile adhesive should then take on an absolutely flat surface. I use this a nice heavy, flat-ground granite slab.
So now, the first pan harden and tomorrow I can start the next one.

  bene bene edwin e anche lo scafo del Tiger prende forma ...    saluti robby62